Step 15 Setting Additional Functions Of Wired Remote Control - Samsung AC BN DCH Series Installation Manual

Installation Procedure
6 Wrap it with the insulation tape twice or more and position your
contraction tube in the middle of the insulation tape.
Method 1
Insulation tape
1.57 inch (40 mm)
7 After tube contraction work is completed, wrap it with the
insulation tape to finish.
Method 1
Insulation tape
CAUTION
• Make sure that the connection parts are not exposed to
outside.
• Be sure to use insulation tape and a contraction tube made of
approved reinforced insulating materials that have the same
level of withstand voltage with the power cable. (Comply with
the local regulations on extensions.)
WARNING
• In case of extending the electric wire, please DO NOT use a
round-shaped Pressing socket.
– Incomplete wire connections can cause electric shock or a
fire.
24
English
Method 2
Insulation tape
1.38 inch (35 mm)
Method 2
Insulation tape
Step 15 Setting additional functions of
wired remote control
Automatic Air-Volume (This function can't be used at
AC***BNLDCH model)
Automatic Air-Volume function must be performed for each
indoor unit with the wired remote control attached.
With its BLDC motor, you can use smart adjust the indoor unit fan
speed depending on the installation condition.
If the external static pressure is high so that the duct becomes
longer or if the external static pressure is low so that the duct
becomes shorter, Using the Automatic Air-Volume function,the
volume of exhaust air has been adjusted to the rated volume flow
rate automatically.
SEG Used
5 6
Main Menu Sub-menu
Performing the Automatic Air-Volume function.
• Check the air conditioning unit stop.
Press the Power button to stop the air conditioner
• Go to Service setting mode with remote controller.
Press the and buttons at the same time for more than 3
1
seconds and then a Main menu will be displayed.
2 Press the / button to select
button to enter a Sub-menu setting screen.
3 Press the / button to select
to enter a automatic air-volume setting screen.
1 2 3 4
and then press
and then press button