Samsung AC BN DCH Series Installation Manual page 37

3 Check whether the option values that you have set are correct by pressing the
[SEG2, SEG3] [SEG4, SEG5]
[SEG14 , SEG15]
[SEG11 , SEG12]
[SEG21 , SEG22] [SEG23, SEG24]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor on the indoor unit and then press the
on the remote control twice. Make sure that this command is received by the indoor unit. When it is successfully
received, you can hear a short sound from the indoor unit. If the command is not received, press the
button again.
5 Check whether the air conditioner operates in accordance with the option values you have set:
a Reset the indoor unit by disconnecting and then reconnecting the power cable of the indoor unit or by pressing
the RESET button on the outdoor unit.
b Remove the batteries from the remote control, insert them again, and then press the
remote control.
Setting the indoor unit address and installation option
[SEG6, SEG8] [SEG9, SEG10]
[SEG16 , SEG17] [SEG18 , SEG20]
(Mode) button repeatedly
(Power) button
(Power)
(Power) button on the
37
English