Kallista P23052-CR Installation Instructions Manual page 6

INSTALLATION INSTRUCTIONS
NOTE: If installing the P24722-LV trim, proceed to the "For P24722-LV" section below.
‰ Place the escutcheon on the wall with the drain notch located downward in the 6 o'clock position.
‰ Thread the handle assembly onto the hub of the front plate assembly to secure the escutcheon in place. A
lever handle should point downward in the 6 o'clock position.
NOTE: If the handle does not engage the valve or the escutcheon does not tighten to the wall, replace the
valve stem adapter with an adapter of appropriate length.
For P24722-LV
‰ Thread the adapter ring onto the hub of the front plate assembly.
‰ Place the escutcheon on the wall with the drain notch located downward in the 6 o'clock position.
‰ Place the handle assembly against the escutcheon by lining up the pins in the handle assembly with the
holes in the escutcheon. Make sure the handle is pointing down to the 6 o'clock position and the setscrew
hole is facing down.
‰ Verify the setscrew will contact the front angle of the adapter ring. Thread the adapter ring in or out until
appropriate setscrew contact is achieved.
‰ Tighten the setscrew with a hex wrench. Make sure the handle assembly is tight against the escutcheon.
1491208-2-A
6 of 16
4. INSTALL THE TRIM
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Thermostatic Valve Trim
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.