Contact Station Interface - IDVille ID MAKER Zenius User Manual

C

Contact Station Interface

Printers fitted only with a smartcard contact station (without integrated encoder)
are fitted with a female DB-9 connector which is found on the back of a printer.
This connector, directly connected to the contact station inside the printer, is also
connected to an external coupler to program the chip.
1
2
3
4
5
6
7
8
9
A sequence of commands must be sent via the printer's interface to insert a card into the printer then position it under the station and establish contact.
DB-9 connector pins
C1 (V c.c.)
C2 (reset)
C3 (clock)
C4 (reserved)
C5 (ground)
C6 (Vpp)
C7 (I/O)
C8 (reserved)
Card present signal
Smartcard contact points
61