Cisco 3110 Hardware Installation Manual page 73

Hide thumbs Also See for 3110:

Table of Contents

Installation, Maintenance, and Upgrade

Figure 47: Remove the SSD

Ejector handle

Step 5

To replace the SSD in slot 1, make sure the power switch is still in the OFF position (if you are replacing SSD-1), and

then hold the SSD with the ejector handle extended in front of slot 1, push it in gently until it is seated, and close the

ejector handle.

Step 6

You can install the RAID1 SSD in slot 2. Make sure the power switch is still in the OFF position, and then remove the

blank faceplate in slot 2 by loosening the handle on the faceplate.

Step 7

Hold the RAID1 SSD with the ejector handle extended in front of slot 2, push it in gently until it is seated, and close the

ejector handle.

Do not switch the two SSDs. The RAID1 SSD must be installed in slot 2.

Caution

Step 8

Check the SSD LED to make sure the SSD is operative. See

LEDs.

Step 9

Add SSD-2 to the RAID configuration using the raid add local-disk 1|2 command.

SSD release tab

Front Panel LEDs, on page 11

Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide

Remove and Replace the SSD

for a description of the SSD

Table of Contents

Chapters

Table of Contents

3120 3130 3140