Cisco 3110 Hardware Installation Manual page 72

Remove and Replace the SSD
Caution
Safety Warnings
Warning
Warning
Step 1
Save your configuration.
Step 2 If you are removing SSD-1 and there is only one SSD installed in the chassis, power down the chassis by moving the
power switch to the OFF position. See
You can only remove the SSD in slot 1 if there are two SSDs installed. If you have only one SSD, you cannot remove it
while the chassis is powered on
Step 3 To remove the SSD in slot 1, face the front of the chassis, and pinch the release tab on the front of the SSD. This causes
the ejector handle to spring open.
Step 4 Grasp the ejector handle to gently pull the SSD out of the chassis.
Cisco Secure Firewall 3110, 3120, 3130, and 3140 Hardware Installation Guide
68
Hot swapping for the RAID configuration is not supported. You can hot-swap SSD-1 if there are two SSDs
installed. To hot-swap SSD-2, you must remove it from the RAID configuration using the raid remove-secure
local-disk 1|2 command.
Take note of the following warnings:
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1073 No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Rear Panel, on page 13
Installation, Maintenance, and Upgrade
for more information on the power switch.