Project Source 67129W-100802 Manual page 4

ASSEMBLY INSTRUCTIONS
1. Shut off the water supply. Remove the old faucet.
Ensure the base plate (B) is on the bottom of the
new faucet (A).
NOTE: Silicone sealant is required under the base
plate (B).
Skip this step if install with side spray.
2. a. Push the plug (E) firmly upward and snap onto
the block (D).
b. Pull down moderately to ensure the connection
has been made.
3. Remove the lock nut (H) from hose guide (G).
Mount the hose guide (G) into the far-right hole in
the sink. Secure the hose guide (G) underneath
the sink using the lock nut (H) and hand tighten.
NOTE: Skip step 3 and step 4 if install without
side spray.
1
B
2
3
4
A
D
E
G
H