Cycle Components; Compressor Removal - Hitachi SAMURAI Series Service Manual

3 Servicing

Cycle components

3.3 Cycle components

!
C A U T I O N
• All operations in the refrigerant cycle require to collect the refrigerant. In those cases proceed as explained
refrigerant"
!
D A N G E R
• Turn OFF all the power source switches and ensure that the module is totally stopped before to get inside.
• Be careful, some parts and components can be at high temperature.
Access inside the module for servicing can be easily done. The unit is open (except the electrical box) and the inner
parts are easily accessible.

3.3.1 Compressor removal


When Removing the Compressor
Remove the compressor while completing the following procedures.
1 Before any other operation, collect all refrigerant as described in chapter
procedure"
2 Remove the bolts on the discharge and suction
flanges of the compressor.
3 Remove the 4 bolts at the upper flange of the
suction pipe.
62 SMGB0120 rev.0 - 11/2017
"Recovering the refrigerant by "Pump-down"
Bolts(x4)
Suction pipe
in"3.3.3 Recovering the
Bolts(x4)
Bolts (x4)
Gasket
Nuts (x4)