Makita UB002C Instruction Manual page 10

Installing the flat nozzle or
extension nozzle
Optional accessory
NOTE: If the end nozzle is installed, remove it before
installing the adapter pipe.
1. Align the triangle mark on the adapter pipe with
that on the swivel pipe, then attach the adapter pipe to
the swivel pipe, and then turn it to lock it into place.
Fig.9
► 1 . Triangle mark 2. Adapter pipe 3. Swivel pipe
2. Align the triangle mark on the flat nozzle or exten-
sion nozzle with that on the adapter pipe, then attach
the flat nozzle or extension nozzle to the adapter pipe,
and then turn it to lock it into place.
1
2
Fig.10
► 1 . Flat nozzle 2. Extension nozzle 3. Adapter pipe
4. Triangle mark
To remove the adapter pipe, flat nozzle, or extension
nozzle, perform the installation procedure in reverse.
1
2 3
4
Adjusting the belt and shoulder
harness
1. Put on the machine, then lock the buckle of the
waist belt, and then adjust the length of the waist belt.
Fig.11
► 1 . Buckle
2. Adjust the length of the shoulder harness.
3
Fig.12
► 1 . Shoulder harness
Adjusting the control lever position
Loosen the clamp screw. Move the control handle along
the swivel pipe to the most comfortable position, and
then tighten the clamp screw.
Fig.13
► 1 . Control handle 2. Swivel pipe 3. Clamp screw
10 ENGLISH
1
1
1
2
3