Advertisement
Factory Test & Alignment Specification For MS08PA-LA Series (V1.0).Doc
Appendix "NETWORK CONNECTION AND TEST"
1.Network connection
You can set up your TV so that it can access the Internet through your local area network (LAN)
using a wired or wireless connection.
1.1Connecting to a wired network
You can attach your TV to your LAN using cable in three ways:
• You can attach your TV to your LAN by connecting the LAN port on your TV to an external modem
using a Cat 5 cable.
• You can attach your TV to your LAN by connecting the LAN port on your TV to a IP Sharer which is
connected to an external modem. Use Cat 5 cable for the connection.
• Depending on how your network is configured, you may be able to attach your TV to your LAN by
connecting the LAN port on your TV directly to a network wall outlet using a Cat 5 cable. Note that the
wall outlet is attached to a modem or router elsewhere in your house.
Select Options > Network > Configuration >Interface, then select Ethernet to connect to a wired
network.
1.2 Connecting to a wireless network
To connect your TV to your network wirelessly, you need a wireless router or modem and a Wireless
LAN Adapter. Connect your Wireless High Gain USB
Adapter (USB dongle) delivered with your TV to your TV's USB 1 port.
1.2.1 Select Options > Network > Configuration >Interface, then select Wireless to connect to a
wireless network.
1.2.2. Select Wireless setting and press OK/► to enter.
1.2.3. Connection Methods: You can setup the wireless network connection three ways.
1.2.3.1 Scan
• Select Wireless setting > Scan, then press OK/►, the TV will scan all access points within range.
The access points found by the TV will be displayed.
• Select an available access point, then press OK/► to connect the TV to it.
Notes:
- If you select a protected access point, you will have to enter the corresponding password.Press
Menu on the remote control to display virtual keyboard to enable you to enter the password.
- This set has a memory function of available access point, which enables your set to be connected
to the network even if you switch on TV after power off.
1.2.3.2 Manual
Select Wireless setting > Manual, then press OK/►, you will be prompted to enter the correct SSID
Page 15 of 18
Advertisement
