Advertisement
Factory Test & Alignment Specification For MS08PA-LA Series (V1.0).Doc
of an available wireless router to setup the connection.
-1.2.3.3 Auto
If your AP supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN (Personal
Identification Number) or PBC (Push Button Configuration). WPS will automatically configure the
SSID and WPA key in either mode. Select Wireless setting > Auto, then press OK/► to enter.
• PIN: Select PIN and press OK/► to enter. Generate a random PIN code. Make sure this code is
installed to the AP. (For the procedures, refer to your router manual.) Press OK/► again to setup the
connection.
• PBC: If your router has a PBC push button, select PBC, then press OK/► to enter. Press PBC
push button on your router within 2 EN 12 minutes after you press OK/► again. Your TV will
automatically acquire all the network setting values it needs and connect to your network.
Network setup
1. Press Menu on the remote control and select
Options > Network > Configuration > Internet connection. Press ◄/► to select On. Wait until the
connection is automatically established.
2. Select Options > Network > Configuration >Connection test, then press OK/► to check the
Internet connectivity. If fail, follow below step to make sure the connectivity.
3. Select Options > Network > Configuration > IP setting, then press OK/► to enter the IP setting
menu.
- Set Address type to Auto, it will acquire and enter the needed IP address automatically.
- You can follow below steps to enter your IP address manually.
• Set Address type to Manual, then press ▼ to go to the first entry field.
• Enter the IP address, Subnet mask, Default gateway, Primary DNS and Secondary DNS values.
Use the digit buttons to enter numbers and the arrow buttons to move from one entry field to another.
- After setting, select Options > Network > Configuration > Connection test to check the Internet
connectivity again.
4. Select Options > Network > Configuration> Information, then press OK/► to display the
information on current connection, such as Interface, Address type, IP address, etc..
Share & See
Note: This manual covers products with either Share& See or DLNA function. Share & See is DLNA
compatible.
Connecting to your PC
Make sure to set up a wired or wireless connection from your TV to a router first. Then connect your
PC to your router either through a network cable or wirelessly. Follow the steps in turn specified
hereafter, then you can enjoy recorded video, picture, music and/or text files saved on your PC.
Adding media from your PC for sharing
Install a DLNA media server in your PC. The simple and familiar server you may install is Microsoft
Windows Media Player 11. Allow your TV to share the designated files on your PC.
1. Open Microsoft Windows Media Player 11.
- Select Library > Media sharing.
- Check the checkbox Share my media to.
- Select the icon of the TV set connected to your PC.
- Select Allow to allow the TV set to access your PC, and select OK to enable your allowing.
Note: You can push Settings button to customize your desired settings.
2. - Select Library > Add to Libray.
- Select your personal folders or folders of other users that you can access for sharing.
- Select Add and press OK to enable your adding.
Share & See application
Page 16 of 18
Advertisement
