Do you have a question about the PRESSURE-FLO and is the answer not in the manual?
Questions and answers
James Mccormick
March 20, 2025
how do i identify the size of laguna filter ,it has 3 foam filters about 10inches diameter 3 inch hole in centre
1 comments:
Mr. Anderson
May 14, 2025
The size of the Laguna Pressure-Flo filter can be identified by matching the foam filter dimensions. A filter with 10-inch diameter foam filters and a 3-inch center hole is likely compatible with the Pressure-Flo 2100/8000 or 3200/12000 models, as these models use larger components.
Page 1
PRESSURE-FLO Instruction Manual Mode d’emploi Bedienungsanleitung Manual de instrucciones Manual de instruções Handleiding Beautifully simple water gardening Aménager un bassin de jardin : merveilleusement simple • Herrlich einfacher Wassergarten • Perfecto para la jardinería acuática Jardim de água maravilhosamente simples • Een watertuin inrichten: wonderbaarlijk eenvoudig...
English Instructions Refer to these illustrations when reading instruction manual. A UV-C Head B UV-C Lamp C Quartz Sleeve D O-Rings E Retaining Flange F UV-C Head O-Ring G Filter Lid H Universal Click-Fit Sealing Cap Click-Fit Head Screws K Quartz Sleeve Flange Screws L Foam Cleaning Blades M Foam Filters N Foam Support Frame...
The power cord of this appliance is a operating current not exceeding 30 mA. special cord; if it is damaged, it must be replaced by an authorized Laguna service 14. WARNING – Do not connect power to ilter unless ilter is fully and correctly facility or similar qualiied person in order to avoid any hazard.
Choose a suitable location for your Pressure-Flo ilter, keeping in mind the following recommendations: • Place the Pressure-Flo Filter on a irm and level base, where it is safe from looding and has enough ventilation. Protect the appliance from direct sunlight.
Page 5
(push button fully up). If the ilter remains clogged at the end of this UVC section of the Pressure-Flo ilter, the quartz sleeve (C) can become coated with operation, inspect the Cleaning Indicator to see whether it is clean and unimpeded limescale, which will diminish the performance of the UV-C lamp (B).
You do not need to completely remove the screws. Just unscrew them until an authorized Laguna dealer or contact Laguna Customer Service. the UV-C Head is disengaged. If on the contrary no water is visible inside the quartz sleeve (C), carefully reassemble 5.
Page 7
Spain: Rolf C. Hagen España S.A., Av. de Beniparrell n. 11 y 13, 46460 Silla, Valencia Malaysia: Rolf C. Hagen (SEA) Sdn Bhd 43200 Cheras, Selangor D.E. Printed in Italy Laguna and Hagen are registered trademarks of Rolf C. Hagen Inc. www.lagunaponds.com...
Need help?
Do you have a question about the PRESSURE-FLO and is the answer not in the manual?
Questions and answers
how do i identify the size of laguna filter ,it has 3 foam filters about 10inches diameter 3 inch hole in centre
The size of the Laguna Pressure-Flo filter can be identified by matching the foam filter dimensions. A filter with 10-inch diameter foam filters and a 3-inch center hole is likely compatible with the Pressure-Flo 2100/8000 or 3200/12000 models, as these models use larger components.
This answer is automatically generated
4500 model pump size ?