Table of Contents
Advertisement
3. If user change source by input source OSD or
RS232/LAN command, source will keep at user
selected source(Don't care Priority setting at this
time until user selected source signal is lost ). If user
selected source
signal is lost, PID will search the active input source
according to the
setting of Signal Priority Check. (even user select
source signal back,
source will not change back to user selected
source).
4. After start signal check priority function, if higher
priority signal exist,
auto switch to higher priority source. If all source no
signal, continue to
search active input source according to the setting of
signal priority check.
5. In search signal of signal priority check setting, the
checking period is about 2 seconds each item. If
user change source manually, the check timeout is
10 seconds.
6. If user select USB-photo or USB-music or
USB-movie, it will follow playlist to play. If user didn't
create playlist, system will depend on USB-photo or
USB-music or USB-move setting to auto play the
photo or music or move file in USB root.
7. In media, if user press EXIT key to leave playing
mode, the auto play behavior will stop.
8. Support source option : AV/Component, HDMI1,
HDMI2, DVD-D, VGA, USB-photo, USB-music,
USB-movie
(only can set one of USB-photo, USB-music and
USB-movie)
9. if signal priority check = enable, Power on source
will search the active source according the setting of
signal priority check. if signal priority check =
disable, power on source will the last source.
10 if signal priority check =enable and power on
18
Advertisement
Table of Contents
