Troubleshooting - Makita CL117FD Instruction Manual

Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard
wooden wall, beam or column, where the wall mount
for cordless cleaner can be firmly secured. Always be
sure that the wall mount for cordless cleaner is securely
attached before hanging the cleaner.
► Fig.37: 1. Wall mount for cordless cleaner 2. Plug

Troubleshooting

Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
Noise and vibration
NOTICE:
Do not attempt to repair cleaner by yourself.
Disposing cleaner
A Li-ion battery is built in this cleaner. Always remove it
before disposing of the cleaner.
Removing built-in battery
CAUTION:
Do not touch the terminals with
any conductive material.
CAUTION:
Avoid storing battery unit in a
container with other metal objects such as nails,
coins, etc.
CAUTION:
Do not expose battery unit to
water or rain.
CAUTION:
Do not disassemble or alter bat-
tery unit.
CAUTION:
The cleaner must be disconnected
from the supply mains when removing the battery.
CAUTION:
Hold the appliance and battery unit
firmly when removing and installing the battery
unit. Failure to do so may cause them to slip off your
hands, resulting in damage to the appliance and
battery unit and personal injury.
CAUTION:
Take care not to trap finger(s)
between the cleaner, rear cover and battery when
removing and installing the battery unit. Trapping
finger(s) may cause injury.
mount violently or hang other appliances than the
cleaner.
NOTE: When you do not charge the cleaner, the plug
can be stored on the wall mount for cordless cleaner
as illustrated.
Area to be investigated
Is the capsule full of dust?
Is the filter clogged?
Is the battery cartridge discharged?
Is the battery cartridge discharged?
Is the filter clogged?
Is the nozzle, pipe or suction inlet of the
appliance is clogged?
Is the nozzle/pipe inlet blocked?
1.
the arrow.
► Fig.38: 1. Rear cover
2.
lead wires from the battery by slightly moving back the
battery while pressing the connector in the direction of
arrow as shown in the figure.
► Fig.39: 1. Connector 2. Lead wires
3.
► Fig.40: 1. Battery unit
4.
that it is not circuit-shorted.
Installing replacement battery
To install the replacement battery, follow the removal
procedure in reverse.
pletely stored inside the cleaner before putting
the rear cover back in the original position. Failure
to do this may damage the lead.
► Fig.41
After installing the battery (see "SPECIFICATIONS"),
charge the battery before use.
15 ENGLISH
CAUTION:
Do not hang the cleaner to the wall
Empty the capsule of dust.
Clean or wash the filter.
Charge the battery cartridge.
Charge the battery cartridge.
Clean or wash the filter.
Remove the clogged objects in the nozzle,
pipe or suction inlet of the appliance.
Do not block the nozzle/pipe inlet.
To remove the rear cover, push it in the direction of
Slide the built-in battery halfway. Disconnect the
Then slide the battery unit out completely.
Put the removed battery unit in a carton box so
CAUTION:
Route the lead so that it is com-
Fixing method