Electrolux EACS/I-HVI/N8 21Y EEC User Manual page 8

8
www.home-comfort.com
Note:
ABOUT TURBO MODE
When this function switched on, the device
starts operating at maximum power for
faster heating or cooling the room.
6 SWING LEFT and RIGHT – this feature is
not used.
Note:
Vertical louvers can be adjusted manually.
7 SWING UP AND DOWN (LOUVER
POSITION)
By pressing SWING UP AND DOWN
button, you can adjust the horizontal
louvers of the internal unit to the
desired angle. The choice of position
of horizontal lovers is carried out in the
following sequence: swing mode includes
the entire airflow angle.
The following shows the main standard
louver positions of the internal unit.
If you press the button
for 2 seconds, the lovers will begin to
swing, then, if the button is released, the
position of the louvers will be fixed in the
selected position.
Also, in the swing mode, by pressing
the button for more than 2 seconds,
the required louver's angle is fixed. This
position will be saved until the next
adjustment.
8 СLOCK
By pressing CLOCK button, you can set
the clock time, the sign
flashing on the display. At the moment
the sign is flashing
you can set the time by pressing "+"
button or "–" button, by continuously
pressing and holding the button for
more than 2 seconds, the time value will
change every 0.5 seconds by 1 value.
After CLOCK sign stops flashing and
a permanently lit sign
on the display, it means the time has
been set. After setting the time, press
CLOCK button again to confirm. After
disconnecting the device from the mains,
the clock must be reset. The indication
sign appears on the display after the
9 TIMER ON (TIMER TURNING ON)
and hold it
10 TEMP (internal unit temperature display)
will start
within 5 seconds
11 HEALTH (ionization mode/fresh air
appears
power supply is turned on. In the clock
display area, the current time or the timer
value is displayed, depending on the
settings.
By pressing TIMER ON button, the timer
turning on feature of the air conditioner
is set. The sign will appear on the
display and flash, at this moment a
flashing clock will appear, with which you
can set the time. Within 5 seconds, while
the clock on the display is flashing, by
pressing "+" or "–" button, the time can
be increased or decreased by 1 minute.
By holding "+" or "-" button for more than
2 seconds, the time can be increased or
decreased by 10 minutes. After the clock
has been set, the sign
on the display and the clock will display
the current time. Press TIMER ON button
to save the time. Now the time is set.
Pressing TIMER ON button again will
cancel the timer feature. The sign
disappear on the display. The timer is
now disabled. Before setting the timer,
the clock must be set to the correct time.
TIMER OFF (TIMER TURNING OFF)
By pressing TIMER OFF button, you can
turn off the timer.
The timer can be turned off while the
sign is flashing on the display. The
method to turn off the timer is the same
as the method to set TIMER ON feature
(TIMER TURNING ON).
By pressing this button, you can select
the temperature display mode on the
internal unit. The display modes change
in the following sequence:
— Display of the set room temperature.
— Display of the current room
temperature.
— Display of current outdoor
temperature.
intake)
When you press HEALTH button, the
remote control display shows
activates the cold plasma generator and
the plasma electrostatic filter.
During operation, cold plasma generator
with positive hydrogen ions H+ and
negative oxygen ions O2 – deactivates
airborne microorganisms, pollen,
allergens.
Plasma electrostatic filter
will appear
will
. This