KitchenAid KSMICM Manual page 7

PRODUCT USAGE
3
Fit the Freeze Bowl in place over the
locating pins. Press down on the back of
the Freeze Bowl until the bowl pin snaps
into the spring latch.
4
Place the Dasher inside the Freeze Bowl.
ATTACHING THE DRIVE ASSEMBLY FOR BOWL-LIFT MIXERS
1
Be sure the Stand Mixer is OFF (0) and
unplugged.
NOTE: The Freeze Bowl is designed to
fit most bowl-lift mixers. If the bowl pin
at the back of the Bowl is too long to
snap into the spring latch, remove and
rotate the Bowl so the blank side faces
the spring latch. Repeat step 3.
2
Make sure the bowl-lift handle is still in
the down position and the Freeze Bowl
and Dasher are in place.
7