Fuel Evaporation System Filter - HUSTLER X-ONE Operator's Manual

Fuel Shut-off Valve
A fuel shut-off valve is located on each mower. The
location and operation of the fuel valve will vary depending
upon the unit. Close the fuel valve to prevent fuel flow to the
engine. The valve's two other positions will allow fuel to be
drawn from either one or the other fuel tank. Figure 4-9
Valve shown in closed position
C
B
A
A. Fuel shut-off valve
B. Left fuel tank position
Figure 4-9

Fuel Evaporation System Filter

These mowers have a fuel evaporation system filter. This
filter must be checked and replaced every 500 hours or
annually whichever comes first. Figure 4-10 & Figure 4-11
Engine Oil and Filter
Allow the engine to cool before changing the
engine oil. If the engine has been running, use
caution when changing the engine oil as it will be
very hot. You should wear the appropriate
protective gear to avoid being burned or exposed
to engine oil.
Check engine oil daily and after every 4 hours of operation.
Machine must be sitting level when checking oil. Refer to
engine manual and maintenance
recommendation and capacities. Hustler
recommended.
Change the engine oil and filter after the first 5 hours of
operation and per
recommendations after that. If mower is being operated in
extremely dirty conditions, then it is recommended oil be
changed more frequently.
606839
D
C. Closed position
D. Right fuel tank position
schedule for
Motor Oil is
®
the engine manufacturer's
A. Fuel evaporation system filter
A
A. Fuel evaporation system filter
oil
IMPORTANT: After the new oil filter has been installed,
clean up any oil which may have spilled onto the engine
plate, engine exhaust system, and muffler guard.
Draining the engine oil:
1. Locate the oil drain valve on the engine. Figure 4-12 &
Figure 4-13
4-5
A
Figure 4-10
Figure 4-11
REV E