Fuel And Evaporative Emissions Control System - HUSTLER X-ONE Operator's Manual

The Hustler X-ONE system filter is located at the bottom
® ®
of the integrated transmission with access to it from the
front. (Figure 4-7) Use a Hustler
When changing the filter use a 3/4" hex wrench. The threads
are right hand.
A
B
A. Dipstick cap
B. Hydraulic reservoir
Figure 4-7

Fuel and Evaporative Emissions Control System

IMPORTANT: Refer to the Safety section of this manual for
fuel handling safety information.
IMPORTANT: Refer to the engine owner's manual for
additional emissions control information.
Use only Hustler approved replacement parts.
®
Your evaporative emission control system may include
parts such as:
• fuel tanks
• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
REV E
approved filter element only.
®
C
C. Hydraulic filter
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
The fuel tanks are located in the mower's fenders.
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
Park the mower on level ground before filling the fuel tank.
Clean the area around the fuel cap before removing the
cap. Remove the fuel cap slowly.
When threading the fuel cap onto the filler neck, tighten the
cap until it begins to click, then, continue to turn it until at
least three clicks are heard.
IMPORTANT: Do not overfill the fuel tanks. The fuel tanks
should be filled no higher than the bottom of the fill neck.
(Figure 4-8) The fuel system is designed to leave room for the
fuel to expand with fuel temperature changes.
Fill to the bottom of the filler neck
Maximum
Do Not
Overfill
A. Filler neck
Overfilling the fuel tank may cause the following:
• Engine damage
• Fire hazard!
Use regular unleaded gasoline with an octane rating of 87
or higher. Maximum of 10% ethanol (E10) in fuel. Fuels with
greater than 10% ethanol (such as E15, E20 and E85) voids
warranty. Fuels with greater than 10% ethanol are not
approved for use and such illegal use could cause equipment
failure and pose a fire hazard.
Refer to the Engine Owner's Manual for additional fuel
specification requirements.
4-4
A
B
B. Fuel tank
Figure 4-8
606839