Table of Contents
Advertisement
MECHANICAL & ELECTRICAL SETUP GUIDELINES
•
Only two cores of the float switch cable are used (check the packaging/instructions with the float
switch to see which colours should be used for emptying). In this condition, a contact closes in the
float switch when raised.
•
The float switch for pump operation needs to hang no longer than halfway down the pump, and
below the inlet level. The pump must not 'run dry' before the float switch reaches its 'off position' .
•
The alarm float switch needs to activate above the pumps float switch level and below the inlet
level.
•
The pump lifting chain should be attached to the handle using the shackle provided so you're able
to lift the pump up without draining the tank. The other end will need to be attached at the top of
the tank.
© Automated Environmental Systems Ltd. February 2022
Single Pump
Twin Pumps
Advertisement
Table of Contents
