7. DEVICE FUNCTION
7.1 Main function
7.1.1 Weed killer
Ensure the extension handle is firmly fixed
onto the device and that device is turned off.
Install weeding nozzle to the device.
Check the nozzle is not blocket before turning
the device on.
Set the temperature to setting Ⅱ.
Allow the device about 45 second to heat up.
Hold the device with extncion handle firmly.
To kill weeds, hold the weeding nozzle over the weeds for about 5 seconds.During these 5 seconds the cell
structure of the weed is destroyed. As a result, weed dies within a few days.
For an efective treatment t weed nozzle should be held around 0 to 5 cm above the weeds.
The effects are not visible immediately but will také a while before they can be seen. It is more of
a long‐term effect.
7.2 Optional function
7.2.1 Charcoal lighter
Allways use without extencion handle. Remove the extencion handle
by pressing and releasing button (5) and pulling the extension handle
form the device.
Attach charcoal lighter nozzle.
Ensure that device is properly positioned. The kickstand could be
used for firmly support the device in the proper position.
Check the nozzle is not blocket before the device turning on.
Set temperature to position
Put tne nozzle under charcoal or wood and wait until you see smoke.
Now blow hot air into the coal or wood from a distance of around
5‐10 cm until the coal or wood is burning properly.
WARNING! To avoid metling nozzlwe or damage devide do not use for longer than necessary.
Remove the device from coals or wood as soon as it start to glow.
Turn off the device and let it cool down.
7.2.2 Horkovzdušná pistole
Heat gun is always used without extencion handle. Remove the extencion
handle by pressing an releasing button (5) and pulling the estencion handle
from device. Then can be heat gun used for loot of kinds of used.
7.3 Changeing nozzles
When installing the nozzle (nozzles), it is necessary to slide the attachment
on the head of the device and slide slightly to the left after the slide, to
secure both parts. When releasing, it is necessary to do the opposite.
Make sure that the tool is switched off and the nozzle has cooled down.
Falling down nozzle can set an object on fire. Nozzles must be mounted
firmly and secure on the unit.
Ⅱ.
23