If you are going to use the tool, vapours and gas can be released during a short time. This can be
harmful for your health. Asthmatics can suffer hindrance of it. Work in ventilated areas or use
protection mask.
Keep main lead away form hot air nozzle.
Keep children and pets in a safe distace from device during useing.
Keep all parts of the body away from the metal heating head. Do not touch before it cooled down.
Carry the appliance by the handle when it´s switched off.
6.3 Turn off imediatly if:
Plug or cable is defective ode damaged.
Switch is damaged
You smell or se smoke caused by scorched isulation from appliance.
6.4 Use of extencion cable
Use only an approved extension cable for the power input of the machine. The minimum conductor
size is 1,5 mm². Damaged cable increase risk of electric injury. Electric conection must be realised only
in dry area.
6.5 Swich on and off / Temperature setting
To switch the tool on, set the ON/OFF switch to position ⅠorⅡ. Some smoke may be emitted after
switching on; this does not indicate a problem.
To switch the tool off, set the ON/OFF switch to position Ⅰ, and let it run for a few minutes. Then set
the ON/OFF switch to position 0.
Let the tool cool down before moving or storing it.
The air temperature can be adjusted to suit a wide range of applications. The table below suggests settings for
different applications.
Setting
Applications
Ⅰ
Drying paint, varnish color shade samples, filler, adhesives, construction joints and stucco
forms
Drying wet timber prior to filling
Removing stickers
Joining adhesives‐Large‐surface gluing with contact adhesives, activation of pressure‐
sensitive adhesives, acceleration of bonding processes, releasing of bonding points as well as
releasing or bonding of edge band or veneer
Waxing and de‐waxing
Shrinking PVC wrapping and insulation tubes
Defrosting of icy stairs and steps, door locks, trunk lids, car doors or water pipes,
refrigerators, ice boxes etc.
Ⅱ
Weed removing
Useing as charcoal lighter
Loosening rusted or tightly fastened nuts and bolts
Removing old and even thick coatings of oil paint , lacquer, varnish and synthetic plaster
Disinfection‐With hot air of 600 °C ‐ you can quickly rid animal sties/stables of bacteria.
Woodworm infestation can be controlled (Caution: Danger of fire! Do not heat up the
wooden surface excessively).
Position Ⅰ
Position Ⅱ
Air flow of both settings is 500 l/min
50 °C (cooling)
600 °C
22