Cleaning And Storage - Beem 03031 Manual

EN
4. Turn the coffee quantity dial (10) clockwise to the quantity of coffee powder you want
(2 – 12 cups).
Note that with a coarse grinding fi neness setting you will get more coffee powder than with a
fi ne grinding fi neness setting.
5. Press the button
6. Pull the collecting container or portafi lter forwards out of the motor unit.
The freshly ground coffee powder can now be processed further.
If you do not want to use the coffee powder directly, you can store it in the collecting
container for several days but, if you have not already done so, place on the lid and make sure
that the silicone stopper is securely fi tted in the lid.
To obtain a successful result, you should keep a very close eye on the ratio of coffee powder
to water. If the water content predominates, the coffee loses its taste. If in turn you use too
much coffee powder, the coffee becomes too strong. The dosing does of course vary just
like tastes vary from person to person and from speciality coffee to speciality coffee, so you
need to slowly get to know your own ideal ratio.

Cleaning and Storage

PLEASE NOTE
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device. These may damage the surface.
•
Tap out the collecting container (3) and its lid, the grinding container (14) and the lid (1) and
clean everything with the cleaning brush that is supplied (6) or wipe with a cloth. If they are
very dirty, detergent and warm water can be used.
• All parts must be completely dry before they are reinserted and used or stored away.
• Wipe down the motor unit (9) with a damp cloth. If necessary, use a little detergent to remove
more intense soiling.
• Check the connecting cable regularly for any damage.
Cleaning the Grinder Shaft
1. Twist the grinding container (14) towards the open lock symbol
The marking on the grinding container
up and off.
2. For a more thorough clean, take out the grinder: Remove the outer ring of the grinder and the
silicone ring. If necessary, unscrew the nut so that the grinding cone can also be removed.
(2) to start the grinding process. The grinder (13) starts to operate.
must be pointing to
on the motor unit (9).
. Pull the grinding container
18