Troubleshooting - Beem 03031 Manual

19
3. Clean the grinder shaft (13) on the inside with the cleaning brush that is supplied (6).
4. If you removed the grinding cone, reinsert this fi rst and fi x it in place with the nut.
Reinsert the silicone ring and the outer ring of the grinder. When you do this, note the mark-
ing on the grinder ring (•) and the main unit (–). These markings must be pointing to each
other.
5. Place the grinding container on the motor unit so that the marking
container is pointing to
it clockwise. It now fi ts correctly on the motor unit again.
Storage
Disconnect the device from the mains power when it is not going to be used for a prolonged
period. Clean the device again if necessary (see the "Cleaning and Storage" chapter) and let it dry
completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and cannot be accessed by children or animals.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem yourself.
If the problem cannot be solved with the steps that are listed, contact our customer service
department.
Do not attempt to repair an electrical device yourself!
Problem
The device cannot
be switched on. / The
grinder (13) does
not start the grinding
process.
The fuse in the fuse box
is triggered.
During use, an
unpleasant smell is
detected.
on the motor unit. Press down the grinding container and twist
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
There is no mains voltage.
Too many devices connected to
the same circuit.
The device is being used for the
fi rst time.
on the grinding
Fix
Correct the fi t of the mains plug.
Try another plug socket.
Check the fuse of the mains
connection.
Reduce the number of devices in
the circuit.
A smell often develops when
new devices are fi rst used. The
smell disappears once the device
has been used several times.
EN