Harbor Breeze MERRIMACK II 41125 Manual page 14

FINAL INSTALLATION
4. Install the blade arm (J) to the underside of the motor
assembly (N) with motor screws (R) previously
removed (Step 6, page 8). Tighten with Phillips
screwdriver (not included).
Repeat for each blade arm (J).
5. Remove one of the three fitter plate screws (O)
from the fitter plate (P) and save. Loosen but do not
remove the other two fitter plate screws (O).
Note: Make sure to keep loose hardware separate to
avoid confusion during installation.
6. Align the two key slots in the light pan (H) with the
loosened fitter plate screws (O). Place the light pan
(H) over the two screws and turn the light pan (H)
clockwise. Then tighten the two fitter plate screws (O).
Re-install the fitter plate screw (O) that was removed
in the previous step and tighten firmly.
4
5
P
6
H
14
R J
O
O
K