Installation Of Ramming System - Sakai RS45 Manual

2.4. Installation of Ramming System

Install the ramming system in the reverse order in which it was removed.
(NOTICE)
• Make sure that no oil, etc. is sticking to the contact surface of the clutch shoe when installing the
centrifugal clutch (20). Check the contact surface of the clutch shoe within the crank case gear
housing at this time as well.
• Ensure that the half-moon key (19) is securely installed when installing the centrifugal clutch.
• If using M10 nuts for engine mounting, tighten them with the torque shown below.
• After installation, adjust the engine speed to the values in the chart below.
Model name
RS45, RS65
RS75
RS45, RS55E
RS65, RS75
(18) M12 nut : 69 N·m (51 lbf·ft)
N•m
Engine mounting M10 nut: 49 N·m (36 lbf·ft)
N•m
Honda engine GX100*
Honda engine GX120*
Robin engine EH09-2*
Robin engine EH12-2*
Idle
1800±150 min
-1
1500±100 min
-1
1400±100 min
-1
1600±100 min
-1
RAMMING SYSTEM
Full throttle
3600 min
-1
3500±100 min
-1
4000±100 min
-1
3600±100 min
-1
5-007