B&G electronics PW-100 Installation And Operation Manual page 6

PW-100 PW-100
V5.1 V5.1
SIREN tone selection
SIREN function allows to choose among 5 different tones: WAIL, Hi-Lo, PHASER, CHIRP,
and YELP.
1. Activate SIREN.
AUX SIREN tone selection
With AUX set to AUX SIREN, it is possible to select the AUX SIREN tone to one of the
available tones (WAIL, Hi-Lo, PHASER, CHIRP or YELP).
It is not possible to set the same tone for both SIREN and AUX SIREN, meaning that while
setting AUX SIREN, the SIREN tone in use will be unavailable; also, if the AUX SIREN tone is
selected for SIREN, AUX SIREN's tone will automatically change.
1. Activate AUX SIREN.
NOTE: WAIL does not sound when SIREN/AUX SIREN is on.
SETTING UP FUNCTIONS
Setting up HORN tone
The default tone is Standard HORN, although the equipment allows to choose between
Standard HORN and B&G HORN, as explained below.
1. Press and hold HORN.
Setting up AUX
AUX allows to either play an auxiliary siren tone, or change the activation state of an
auxiliary load up to 15 A (useful to control a light set or other devices). If AUX LOAD is
active, the keypad starts to fl ash once per 8 sec.
1. Press and hold AUX.
If it beeps once or twice, it's set to AUX
LOAD.If siren stops & restarts, it's set
to AUX SIREN.
Setting up AUX LOAD
With AUX set to AUX LOAD, it is possible to set AUX LOAD in a way that it gets activated
together with SIREN (for instance, that when SIREN sounds, a light set associated to AUX
LOAD turns on)*, in addition to the activation by pressing AUX.
1. Press and hold AUX until you hear
1 beep.
*By default, AUX LOAD is set to activate independently from SIREN.
2. While SIREN is sounding press WAIL repeatedly to switch to the
available tones (WAIL, Hi-Lo, Phaser, CHIRP and YELP).
2. While AUX SIREN is sounding press WAIL repeatedly to switch
to the available tones (WAIL, Hi-Lo, Phaser, CHIRP and YELP).
2. While HORN is held, press and hold
SIREN until the tone changes.
2. Press SIREN to switch among AUX LOAD and
AUX SIREN.
If it beeps once or twice, it's set to AUX LOAD.If
siren stops & restarts, it's set to AUX SIREN.
2. Press HORN to switch AUX LOAD mode.
If it beeps once, it's set to independent.
It it beeps twice, it turns on with SIREN.
3. To change tone again, repeat steps
1 & 2.
3. Press AUX to fi nish setup.
Upon fi nishing beeps twice.
3. Press AUX to fi nish setup.
6 6