B&G electronics PW-100 Installation And Operation Manual page 3

PW-100 PW-100
V5.1 V5.1
Microphone + shell assembly procedure
1. Insert the cable in the shell by pressing it with your fi nger.
3. Remove the liner from the tape and stick it to the shell.
Location A
Inside the rearview mirror.
This location offers the highest
volume yet the most time
consuming installation, as it
requires to take parts of the
vehicle apart.
Location B*
In the gap of the front doors.
Select a surface to place the
microphone, so that it faces to
the exterior from inside the gap.
Once the surface is selected,
the installation is fairly easy.
* WARNING!
On location B, place the
microphone slightly
downward to prevent
damage from water
clogging.
2. Push the microphone into the shell (do not pull the cable!).
4. Stick the shell on the selected surface, previously cleaned
with alcohol.
Recommended locations to install the microphones
There are two recommended locations in the vehicle
(see fi gure to the left), they differ with regard to ease
of installation and audio reception volume.
You can select a location according to your
preferences.
3 3