B&G electronics PW-100 Installation And Operation Manual page 2

PW-100 PW-100
V5.1 V5.1
COMPONENTS AND RECOMMENDED LOCATIONS IN THE VEHICLE
(1) Electronic unit
(1) Digital keyboard & internal microphone
(1) 100W loudspeaker
(2) External microphones
(1) Internal speaker
(1) Keyboard harness
(1) Power cable (battery)
(1) Fuse 15A
(1) Speaker extension cables
(1) Loudspeaker and auxiliary load harness
INSTALLATION AND ELECTRIC DIAGRAM
To install the equipment, see the wiring diagram shown further on.
Avoid leaving visible cables in the cabin to leave the vehicle's aesthetics unaffected.
If there are any cables left disconnected, insulate them with tape; disconnected cables
making an undesired contact can cause a malfunction.
Electronic Unit
Place it on a hidden location for aesthetic purposes. Make sure that the
location allows some ventilation into the unit to avoid overheating.
Digital Keyboard
To facilitate the handling of the equipment, place the keyboard on a location
within the driver's reach, such as the console of the vehicle. To ensure an
adequate adherence, clean the surface where the keyboard is to be sticked.
Remove the protective liner from the adhesive pad in the back side and stick
it to the surface.
To clean the keyboard, gently wipe it with a dry cloth. Do not use water or any
solvent.
Loudspeaker
When selecting the location for the loudspeaker, keep in mind that
this component is weather resistant but it is not immersion-proof. The
loudspeaker must be placed as far as possible from the keyboard (where the
internal microphone is) to prevent feedback.
Splice and tape the loudspeaker wires to the output wires (they have no
polarity).
External Microphones
Two locations are recommended for installation, as explained on the next
page.
Internal Speaker
Place the speaker out of view, without affecting the sound.
EXTERNAL MICROPHONES INSTALLATION INSTRUCTIONS
Shell
Microphone
Mounting
tape
INTERNAL SPEAKER
Each microphone includes a shell to hold it in
place and protect it from outdoor. Depending
on the installation procedure, it can be more
convenient to assemble microphone and shell
either before or after the wiring.
For instance, if the wiring requires to pull
the cable through a narrow space, it is
recommended to assemble after wiring.
EXTERNAL MIC
DIGITAL KEYBOARD
& INTERNAL MIC
ELECTRONIC UNIT
PW-100
100W
LOUDSPEAKER
EXTERNAL MIC
2 2