Set Button; Display Button; Power Switch - Sony LMD-1041 Operating Instructions Manual

Remote Commander
1 MUTING button
Mutes the sound. Press again to cancel muting (page 9).

2 DISPLAY button

Displays the indicator. Press again to turn off the
indicator.
3 U SCAN button
Switches the screen size and image area.

4 POWER switch

Turns power on or off.
5 Signal input button
Selects the input signal.
LINE A button
Selects the video/audio signal input through the LINE
A connectors !ª.
LINE B button
Selects the video/audio signal input through the LINE
B connectors !•.
LINE C button
Selects the computer/audio signal or the video/audio
signal input through the LINE C connectors !¶. Each
press of this button selects either signal alternately.
6 ID OFF button
Switches from index mode to normal mode (page 11).
7 +/– buttons
Adjusts the selected parameter.
8 VOL +/– button
Adjusts the sound volume.
9 Battery compartment
Insert two size AA (R6) batteries.
!º RESET button
Recalls factory settings of the adjusting parameters
excluding INDEX, U SCAN, LIGHT, MUTE and DISP.
Press twice.
!¡ Adjusting parameter button
After selecting an adjusting parameter with these
buttons, adjust with the +/- buttons 7.
The function of each button is identical with those on
the monitor.
!™ ID ON button
Switches from normal mode to index mode (page 11).
!£ SET button
Sets the index number (page 11).
You can assign an index number to each unit. When
two or more units are installed at the same location, use
this index number to select a unit you want to control
using the remote commander.
Inserting the batteries
1 Slide the lid to remove it.
2 Insert two size AA (R6) batteries by matching the '
and ' on the batteries to the ' and ' in the battery
compartment.
3 Slide the lid to replace it.
Battery life
You can expect the remote commander to operate for about
six months (using Sony SUM-3 (NS) batteries) before the
batteries run down. When the batteries no longer operate
the remote commander, replace all the batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote commander for a long
time, remove the batteries to avoid damage caused by
corrosion from battery leakage.
J
EN
D
F
ES
I
7