Sony LMD-1041 Operating Instructions Manual page 24

Functions of Controls
Rear • Bottom
!™ MAIN POWER switch
Turns on or off the main power of the unit.
!£ Hanging plate
You can hang the unit on the wall, or attach the stand
and place on a table.
!¢ Security lock (
)
You can attach the Kensington's security cable (not
supplied).
!∞ RESET button
Recalls factory settings of the adjusting parameters
excluding INDEX, U SCAN, LIGHT, MUTE and DISP.
Press twice.
!§ CONTROL connector (4-pin)
Connect to the control jack of the equipment with which
you want to control this unit. The signal protocol is
VISCA.
!¶ LINE C signal input connectors
Inputs the analog RGB (computer/video)/YUV (Y/B-
Y/R-Y) signal.
IN connector (3-row D-Sub 15-pin)
Connect to the RGB or YUV (Y/B-Y/R-Y) signal output
of video equipment or a computer.
AUDIO IN connector (phono)
Connect to the audio output of video equipment or a
computer.
!• LINE B signal input/output connectors
Inputs/outputs the Y/C signal of NTSC/PAL system.
Y/C IN connector (4-pin)
Connect to the Y/C video signal output of video
equipment.
Y/C OUT connector (4-pin)
Loop-though output of the Y/C IN connector. When no
cable is connected, Y/C IN signal is terminated at 75 .
AUDIO IN connector (phono)
Connect to the audio output of video equipment.
6
!ª LINE A signal input/output connectors
Inputs/outputs the Composite signal of NTSC/PAL
system.
VIDEO IN connector (BNC)
Connect to the composite video signal output of video
equipment.
VIDEO OUT connector (4-pin)
Loop-though output of the VIDEO IN connector. When
no cable is connected, VIDEO IN signal is terminated at
75 .
AUDIO IN connector (phono)
Connect to the audio output of video equipment.
@º AC IN connector
Plug in an AC power cord.
@¡ CONTROL S IN/OUT connector
Connect to the CONTROL S jacks of other Sony
equipment. It is then possible to control the whole
system with a single remote commander.
@™ PHONES jack
Connect headphones (not supplied).