Functions - Duramaxx Powerpoint Manual

EN

FUNCTIONS

Power button/balance button
To use the power button as a balance button, press it lightly once. The LED
light will flash twice and the unit will vibrate twice briefly. The white LED light
will then illuminate, indicating that the pinpointer is connected and balanced
and is now ready to function. Whenever you press the power button once
briefly, the pinpointer is automatically balanced.
To switch off, please press the power button for about 3 seconds. The white
LED light will go out and the unit will switch off.
LED signal strength indicator and vibration alarm
When metal is detected, the unit starts vibrating and the red LED indicator
lights up. As the research rod approaches a metal target, the vibration
frequency will increase. The LED light will light up in the sequence red, green,
blue and white. Additionally, when the white light comes on at the end, the
vibration frequency will be at its highest.
Illumination LED
After switching on the pinpointer, the white LED will light up. The pinpointer
can then be used and the white LED light can be used as a torch if required.
Search probe
The built-in antenna is used to transmit and receive signals. 360°
omnidirectional locating with 2-3 cm precision locating are at the tip of the
probe.
Low battery alarm
When the battery is low, the LED light will flash continuously. This means that
you should now change the 9 V battery.
20