Table of Contents
Advertisement
To turn password protection on and off
1
Display the Power On Password setting screen by performing steps 1 through 5
of the procedure under "To change the password" on page 15.
At this time, make sure that "Power On Password" is selected on the Power On
Password setting screen.
2
Use the [ ] and [ ] keys to select "On" or "Off".
Changing the power on password setting from "Off" to "On" causes the confirmation
dialog box shown below to appear.
Press the [ENTER] key to confirm that you want to turn on power on password
protection, or [ESC] to exit the dialog box without doing anything.
3
After you are finished, press the [MENU] key to exit the setup menu.
Entering the Password when Turning On the Projector
When you turn on the projector while password protection is turned on will cause a
password input dialog box to appear on the projection screen. All projector operations will
be accessible to you after you input the correct password and press the [ENTER] key.
Note
You can perform the projection size adjustment operation ([ZOOM +] / [ZOOM –] keys),
focus operation ([FOCUS
while the password input dialog box is on the projection screen.
] / [FOCUS
] keys), and power off operation ([
16
] key)
Advertisement
Table of Contents
