Table of Contents
Advertisement
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
Charging the battery via charger jack plug
(HLVC315J11 and HLVC320J11 only) (Fig. E)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch (1) pressed.
Insert the charger jack plug into the charging port.
u
Plug in the charger. Switch on at the mains.
u
The LED indicator wiil light up.
u
While charging, the charger may become warm. This is
u
normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C.
Cleaning the filters (Fig. G, H, I, J)
Rotate the dust bowl (3) in a counterclockwise direction to
u
release from the appliance body as shown in figure G.
Take out the filter assembly (9) from the dust bowl (3).
u
The prefilter (9) and filter (9a) can be seperated and
u
rinsed with water and should be dried afterwards.
Dispose of the dirt inside the dust bowl as shown in figure
u
J. The dust bowl can be rinsed by water.
However it needs to be dried afterwards.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your BLACK+DECKER
dealer
Storage
The unit can be safely stored using the charging station.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
(Original instructions)
not use any abrasive or solvent-based cleaner.
Z
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Note:
BLACK+DECKER's policy is one of continuous
u
improvement to our products and, as such, we reserve the
right to change product specifications without prior notice.
Standard equipment and accessories may vary by coun-
u
try.
Product specifications may differ by country.
u
Complete product range may not be available in all coun-
u
tries. Contact your local BLACK+DECKER dealers for
range availability.
Technical data
HLVC315B11, HLVC315J11
Voltage
(V
)
dc
Battery
Weight
(Kg)
Charger
S003AQS1500015
Approx
charge
time (h)
Input
Voltage
(V
)
ac
Output
Voltage
(V
)
dc
Current
(mA)
Australia & New Zealand
Stanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
810 Whitehorse Road Box Hill VIC 3128, Australia
ENGLISH
HLVC320B11, HLVC320J11
12
1.5Ah
0.71
S003AQS1500015
10
100 - 240V
15
150
12
2.0Ah
0.71
13.5
100 - 240V
15
150
7
Advertisement
Table of Contents
