JVC HX-Z10 Service Manual page 30

3.3.6 Reattaching the Play/ Record & Clear head
(See Fig.11~13)
(1) Reattaching the head mount assembly.
a) Change front of the direction cover of the head
mount assembly to the left (Turn the head forward).
b) Fit the bosses O', P', Q', U' and V' on the head mount
assembly to the holes P and V, the slots O, U and Q
of the mechanism sub assembly (See Fig.11 to 13).
CAUTION:
To remove the head mount assembly, turn the direction
cover to the left to disengage the gear. If the gear can not
be disengaged easily, push up the boss Q' slightly and
raise the rear side of the head mounts slightly to return
the direction lever to the reversing side.
(2) Tighten the azimuth screw for reversing.
(3) Reattach the spring from the back of the Play/ Record &
Clear head.
(4) Connect the flexible wire to connector
amplifier & mechanism control board.
All manuals and user guides at all-guides.com
CN31 on the head
U'
Head mount assembly
Fig.11
Head mount assembly
O
P Q
V
U
Fig.12
Head
Spring
Flexible wire
CN31
Fig.13
O'
P' P'
V' V'
Direction cover
Q'
Direction cover
Azimuth screw for reversing
Head mount
Head amplifier &
mechanism control board
(No.MB014)1-33