C-lock SmartFeed Pro Manual page 9

To power on SmartFeed:
1. Depending on your SmartFeed setup, you may have a different method of
applying power to the unit, either a power switch or a power connector. Ensure
the power source is connected to your SmartFeed unit, and if applicable, turn the
power switch to ON.
2. The power indicator light on SmartFeed will illuminate, to signify that it has
power.
3. Once power is applied, please allow ~1 minute for the system to initialize.
4. Use the mobile Control Feed application to scan for your system to ensure it is
fully powered on and ready.
To power off SmartFeed:
1. Locate the power receptacle. (See Figure 8.)
2. Pull the white tab out.
3. Push down on the black latch and wiggle the connector back and forth while
pulling it outward. (See Figure 5)
Figure 5) Steps for Disconnecting the Power Cable
8