Connecting To A Network - C-lock SmartFeed Pro Manual

1. Remove the bolts and washers from these four spots.
2. Raise or lower the bin supports to the desired height and place the four bolts
back in place.
3. Adjust the door height to accommodate the new front height. See Section 2.1
2.4.2 - The lip of the bin can also be adjusted up or down or removed completely by
removing the screws shown below:
2.5.

Connecting to a Network

SmartFeed must have at least one of the following types of connection:
● WiFi - requires configuration when connecting to a new WiFi network.
● Ethernet - requires additional equipment and an ethernet cable run to SmartFeed.
● Cellular - requires a cellular modem (available at additional cost). A monthly cellular
data plan charge may apply, depending on the cellular provider.
In order for multiple SmartFeed Pro systems to synchronize their feed intake records
with each other, they must communicate over an internet connection.
Failure to synchronize may result in animals being allowed more feed than the user
specifies. For SmartFeed systems that are within 100 feet of each other, it is
recommended to connect them to the same network (usually WiFi). This will ensure
Figure 10) Adjusting the Bin Lip Height
14