Troubleshooting - Insignia NS-IMC44S3 User Manual

Gain access to the water separator pipe by lifting the left and right sides of the
2
pipe from its recess, do not pull the pipe out of the silicone tube on the right.
Clean each hole in the water separator pipe with a paper clip or toothpick.
3
Reattach the left and right sides of the water pipe by inserting it into the
4
recess from which it was removed. Make sure that the holes are facing down.
Clean the water tank and water reservoir with lemon water, using a soft cloth.
5
Drain the water tank and water reservoir, then rinse with clean water and drain
6
again (see Draining the water from your ice maker on page 10).

Troubleshooting

CAUTION: Do not try to repair your ice maker yourself. Doing so invalidates the warranty.
Notes:
• Make sure that the water tank, water filter, and water separator pipe are not blocked.
• Water temperature affects the speed at which ice is made. The lower the temperature,
the faster ice cubes are made.
• The cooler the ambient temperature, the faster ice cubes are made.
• Always use good quality water (clean and relatively soft) in your ice maker. If you use
hard or dirty water, your ice maker will still work, but the pump may be noisy.
• If you turn your ice maker off then turn it back on, the compressor takes three minutes
to restart.
PROBLEM POSSIBLE CAUSE
The (add No water in the reservoir.
water) indicator
lights
The (add The water inlet valve is
not working.
water) indicator
lights with water
in the reservoir
The ice has a bad Various
taste or there is
an odor
Water separator pipe
POSSIBLE SOLUTION
Turn off your ice maker and add water to the
water reservoir, then press the
button to turn on your ice maker and begin
making ice.
Have your ice maker serviced by a qualified
technician.
• Make a few loads of ice after unpacking and
discard the ice
• Clean your ice maker with lemon water
• Use filtered water
www.insigniaproducts.com
44-lb. Clear Ice Maker
(ON/OFF)
13