Getting Ready; Loading Remote Controller Batteries; Setting Up The Projector - Casio XJ-M140/XJ-M145* Setup Manual

Loading Remote Controller Batteries

Important! Important! Important!
Be sure to use alkaline batteries only.
*
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
Caution
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
1.
Open the battery cover on the back of
the remote controller.
3.
Close the battery cover on the back of the remote controller.
Replacing Remote Controller Batteries
Open the battery cover on the back of the remote controller, replace the old batteries with new ones, and
then close the battery cover.
Important! Important! Important!
To avoid running down the batteries, store the remote control unit so its buttons are not
pressed inadvertently.

Setting Up the Projector

Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow sufficient space
around the sides and back of the projector for proper ventilation. The following illustrations show how the
projector should be oriented for optimum projection relative to the screen.
XJ-M140/XJ-M145/XJ-M150/XJ-M155
Screen
Make sure the projector is at a right angle to the screen.
The projector can be configured for projection from the back of a screen. For details, see the User's
Guide on the CD-ROM that comes with the projector.

Getting Ready

2.
Load two new batteries into the case,
making sure that their positive (+) and
negative (–) ends are facing correctly.
Position the projector so the lens side is at the edge of the
table, etc.
E-11
XJ-M240/XJ-M245/XJ-M250/XJ-M255
Screen