Table of Contents
Advertisement
Installing a Replacement Chip
As the value of some chip components is
not indicated on the body of the chip, be care
ful to get the right part for replacement.
Apply a small amount of solder to the land
D
on one side where the chip is to be installed.
Avoid too much solder, which may cause
bridging (shorting to other parts).
Hold the chip with tweezers in the desired
D
position, and apply the soldering iron with
a motion line that indicated by the arrow in
the diagram below. Do not apply heat for
more than
seconds.
3
Remove the tweezers and solder the elec
D
trode on the other side in the manner just
described.
"Ji'T_ fl.!/ fl Tar>hnir>al .t;:rrnnlamanf
Advertisement
Table of Contents
