Connecting To A Component Video Output Device - Casio pmn User Manual

Appendix

Connecting to a Component Video Output Device

Some video devices are equipped with a component video output terminal. You can use an
optionally available component video cable (YK-3) to connect the RGB input terminal of the
projector to the component video output terminal of a video device.
Always turn off the projector and the video device before connecting them.
Projector
RGB input terminal
Optional component video cable
(YK-3)
Component video output terminals come in 3-terminal sets: Y·Cb·Cr or Y·Pb·Pr. Be sure to
match the colors of the plugs on the optional YK-3 component video cable with the colors
of the terminals (Green: Y; Blue: Cb/Pb; Red: Cr/Pr).
You can use the optional YK-3 component video cable to connect to pin jack (RCA) type
component video output terminals. The projector does not support connection to any other
type of terminal.
Note that connection only to an analog component video output terminal is supported.
Connection to a digital output terminal is not supported.
In order to connect to a component video terminal, you must use the setup menu to
configure input settings. For details, see "Input Settings
AUDIO input terminal
Commercially available audio cable
To AUDIO output
terminal
To Component video
output terminal
RGB Input" on page 42.
66
Video device