Casio pmn User Manual page 6

Projection Operations
Manually Selecting the Input Source
The procedure you should use to select the input source depends on whether you are using
projector keys or remote controller keys.
[Projector]
To select the input source using projector keys, press the [INPUT] key on the projector to
cycle through input sources in the sequence shown below.
(RGB/Component)
To select the input source using remote controller keys, press the [RGB/COMPONENT],
[VIDEO], or [S-VIDEO] key on the remote controller to select the input source you want.
The currently selected input source name is shown in the upper right corner of the projection
screen.
If the currently selected input source is not sending an input signal, the message "No
signal input" appears in place of the input source name.
Whether the displayed input source name shows [RGB] or [Component] depends on the
current "Input Settings
projector's setup menu.
[INPUT] key
RGB Input" (page 42) setting that is configured on the
(VIDEO)
6
[Remote Controller]
ZOOM FOCUS
[RGB] key
RGB VIDEO
AUTO P-IN-P
[VIDEO] key
MUTE FREEZE
[S-VIDEO] key
(S-VIDEO)
D-ZOOM
S-VIDEO
VOLUME