Maintenance - RADLEY 5044-032 Owner's Manual

1600PSI PRESSURE WASHER

MAINTENANCE

WATER FILTER AND NOZZLE CLEANING INSTRUCTIONS
A clogged or partially clogged water filter or nozzle can cause significant reduction of
water pressure coming out of the nozzle and/or cause the unit to pulsate while spraying.
1. The water filter was installed inside the water inlet quick connector, should be
cleaned periodically. Rinse it with clean tap water, and then place it back into the
water inlet quick connector.
2. Using the nozzle tip cleaner provided (or an unfold paper clip), insert the wire into
the nozzle hole and move back and forth until debris is dislodged. Back flush water
through the nozzles using garden hose and highest pressure available (either stan-
dard water nozzl or use your thumb over the nozzle to create water pressure for back
flush).
STORAGE
Do not store pressure washer outdoors.
Do not store pressure washer where it might freeze while there's water inside the ma-
chine.
Serious damage will occur to the water system, pump and / or motor.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER
1. Never operate machine without water.
2. Pressure washer is not meant to pump hot water. Never connect to hot water supply
this will significantly reduce life of the pump.
3. Using detergent other than those formulated for pressure washers may cause damage
to pump components (o-rings, etc.). This also applies to chemicals such as bleach,
dish soap, etc.
4. Never operate unit for more than one minute without spraying water. Resulting heat
buildup will damage pump.
5044-032
14