Related Manuals for RADLEY 1900PSI
Summary of Contents for RADLEY 1900PSI
- Page 1 5044-033 1900PSI PRESSURE WASHER 1900PSI PRESSURE WASHER OWNER’S MANUAL 2 Year Limited Warranty on tool WEAR CSA APPROVED WEAR EAR WEAR FACE EYE PROTECTION PROTECTION PROTECTION...
-
Page 2: Product Specifications
PRODUCT SPECIFICATIONS 1900PSI PRESSURE WASHER Rated voltage AC 120 V , 60 Hz Rated current 13 A Rated pressure 1300 PSI Maximum pressure 1900 PSI Maximum water inlet pressure 170 PSI Maximum water inlet temperature 122°F / 50°C Rated flow 1.4 GPM... -
Page 3: Table Of Contents
5044-033 1900PSI PRESSURE WASHER TABLE OF CONTENTS Product Specifications ......................1 Table of Contents ........................2 Safety Warnings ........................3 Included Pieces ........................7 Preparation for Operation ....................8 Operation ..........................11 Maintenance ........................14 Troubleshooting ........................15 Exploded View ........................17 Parts ............................18... -
Page 4: Safety Warnings
IMPORTANT! SAFETY INSTRUCTIONS ALL OPERATORS MUST READ THESE INSTRUC- TIONS BEFORE USE SAFETY WARNINGS DANGER To reduce the risk of fire, electric shock, explosion or injury to people, read the follow- ing: ∫ This product is intended for domestic outdoor use only. ∫... - Page 5 5044-033 1900PSI PRESSURE WASHER CAUTION - WATER CONNECTIONS ∫ For use with fresh and clean water only. Do not use this product with other liquids. ∫ The water supply system must be protected against back flow. ∫ Never use this product with water contaminated with solvents (e.g. paint thinners, gasoline, oil, etc.).
- Page 6 IMPORTANT Stairs Lawn Vehicle Driveway equipment Siding Fencing Deck or patio Garage SAVE THESE INSTRUCTIONS FOR REFERENCE SAFETY WARNING AND ELECTRICAL INFORMATION The pressure washer is equipped with a stop device that senses when the trigger on the spray gun is released. It will open the power circuit to the motor and cause the pressure washer motor to stop.
- Page 7 5044-033 1900PSI PRESSURE WASHER SERVICING OF A DOUBLE INSULTATED APPLIANCE In a double insulated product, two systems of insulation are provided instead of grounding. Grounding means are not provided for a double insulated product, nor should grounding means be added to the product. Servicing a double insulated product requires extreme care and knowledge of the system, and should only be done by quali- fied service personnel.
-
Page 8: Included Pieces
INCLUDED PIECES When unpacking this product, check to make sure parts listed below are included and carefully inspect for any damage that may have occurred during transit. If any part is missing and damaged, do not attempt to assemble or use the product. 1. -
Page 9: Preparation For Operation
5044-033 1900PSI PRESSURE WASHER PREPARATION FOR OPERATION ALWAYS USE THE HANDLE TO TRANSPORT. HOW TO SET UP YOUR UNIT 1. Install gun holder. 2. Install hose reel handle to machine body with two screws in the package. NOTE: When you have screws assembled, it means that the hose reel handle has been assembled successfully. - Page 10 4. Insert the lance into the gun. Push and turn the lance clockwise onto the gun until hand tight to lock it in place. When the pieces are joined properly, you cannot sepa- rate the two components by pulling straight out on the lance. All attachments must be inserted into the gun for proper use.
- Page 11 5044-033 1900PSI PRESSURE WASHER 6. Attach the high pressure hose to the gun. 7. Attach the garden hose. Connect one end of the home garden hose (not supplied) to the adapter and another end to water source. WARNING: The appliance is intended to be used at a temperature above 32°F/ 0°C.
-
Page 12: Operation
OPERATION TO WASH WITH WATER 1. Turn on the water supply tap. Connect the washer to the power supply and turn the switch to “ON/I” position. Then press trigger. NOTE: Before pressing trigger, make sure lock-off switch on the trigger is in “unlock” position. - Page 13 5044-033 1900PSI PRESSURE WASHER has the least power stream. WARNING! Remember to change the nozzle when the gun is off, to ensure that they do not accidentally eject with force during removal. Pull in the nozzle. Pull out the nozzle.
- Page 14 5. Add and use detergent. Detach the soap tank cap and add appropriate detergent. Then install the soap tank cap. Attach the soap nozzle, turn soap adjusting knob left and right to decrease and increase the dosage. NOTE : If necessary, use a funnel (not supplied) to prevent accidental overflows of detergent outside of the tank.
-
Page 15: Maintenance
5044-033 1900PSI PRESSURE WASHER MAINTENANCE WATER FILTER AND NOZZLE CLEANING INSTRUCTIONS A clogged or partially clogged water filter or nozzle can cause significant reduction of water pressure coming out of the nozzle and/or cause the unit to pulsate while spraying. -
Page 16: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE AND SOLUTION Unit will not start. Make sure the power washer is in the “OFF” posi- tion. Plug in the electrical cord. to a grounded 120 volt outlet (no electrical extension cord should be used). If the electrical cord will not plug into your outlet, your electrical outlet is not properly ground- ed and should not be used. - Page 17 5044-033 1900PSI PRESSURE WASHER I can’t remove the lance from All lances and detergent tank are attached and the spray gun. What should I removed from the spray gun in the same manner. Insert the quick-release end of the lance togeth- er (about a1/8”/3.175 mm) and turn clockwise.
-
Page 18: Exploded View
EXPLODED VIEW... -
Page 19: Parts
5044-033 1900PSI PRESSURE WASHER PARTS LIST WARNING: When servicing, use only original equipment replacement parts. The use of any other parts may create a safety hazard or cause damage to the Pressure Washer. Any attempt to repair or replace electrical parts on this Pressure Washer may create a safety hazard unless repairs are performed by a qualified technician.For more informa-... - Page 20 BUAK021027 motor fan housing BUAK021028 gun holder BUAK021029 O-ring 8*2 BUAK021030 wheel BUAK021031 wheel cover BUAK021032 main switch BUAK021033 switch pole BUAK021034 switch cover BUAK021035 wind outlet filter BUAK021036 front housing BUAK021037 knob BUAK021038 knob ornamental BUAK021039 water outlet button BUAK021040 motor upper clamp BUAK021041...
-
Page 21: Warranty
WARRANTY RADLEY PRESSURE WASHER WARRANTY If this Radley tool fails due to a defect in material or workmanship within two years from the date of purchase, it has a 2-year repair warranty with the original bill of sale. This warranty does not include expendable parts including but not limited to blades, brushes, belts, light bulbs and or batteries. - Page 22 © 2021 Home Hardware Stores Limited Made in China 1-866-206-0888 Customer Service/Tech Support This Radley® product carries a two (2) year LIMITED warranty against defects in workmanship and materials. See Owner’s Manual for full details. READ ALL INSTRUCTIONS BEFORE FIRST USE.
Need help?
Do you have a question about the 1900PSI and is the answer not in the manual?
Questions and answers