Related Manuals for RADLEY 5044-032
Summary of Contents for RADLEY 5044-032
- Page 1 5044-032 1600PSI PRESSURE WASHER 1600PSI PRESSURE WASHER OWNER’S MANUAL 2 Year Limited Warranty on tool WEAR CSA APPROVED WEAR EAR WEAR FACE EYE PROTECTION PROTECTION PROTECTION...
-
Page 2: Product Specifications
PRODUCT SPECIFICATIONS 1600PSI PRESSURE WASHER Rated voltage AC 120 V , 60 Hz Rated current 11.5 A Rated pressure 1150 PSI Maximum pressure 1600 PSI Maximum water inlet pressure 170 PSI Maximum water inlet temperature 122°F / 50°C Rated flow 1.4 GPM Machine weight 14.5 lbs / 6.6 kg... -
Page 3: Table Of Contents
5044-032 1600PSI PRESSURE WASHER TABLE OF CONTENTS Product Specifications ......................1 Table of Contents ........................2 Safety Warnings ........................3 Included Pieces ........................7 Preparation for Operation ....................8 Operation ..........................11 Maintenance ........................14 Troubleshooting ........................15 Exploded View ........................17 Parts ............................18... -
Page 4: Safety Warnings
IMPORTANT! SAFETY INSTRUCTIONS ALL OPERATORS MUST READ THESE INSTRUC- TIONS BEFORE USE SAFETY WARNINGS DANGER To reduce the risk of fire, electric shock, explosion or injury to people, read the follow- ing: ∫ This product is intended for domestic outdoor use only. ∫... - Page 5 5044-032 1600PSI PRESSURE WASHER CAUTION - WATER CONNECTIONS ∫ For use with fresh and clean water only. Do not use this product with other liquids. ∫ The water supply system must be protected against back flow. ∫ Never use this product with water contaminated with solvents (e.g. paint thinners, gasoline, oil, etc.).
- Page 6 IMPORTANT Stairs Lawn Vehicle Driveway equipment Siding Fencing Deck or patio Garage SAVE THESE INSTRUCTIONS FOR REFERENCE SAFETY WARNING AND ELECTRICAL INFORMATION The pressure washer is equipped with a stop device that senses when the trigger on the spray gun is released. It will open the power circuit to the motor and cause the pressure washer motor to stop.
- Page 7 5044-032 1600PSI PRESSURE WASHER SERVICING OF A DOUBLE INSULTATED APPLIANCE In a double insulated product, two systems of insulation are provided instead of ground- ing. Grounding means are not provided for a double insulated product, nor should grounding means be added to the product. Servicing a double insulated product re- quires extreme care and knowledge of the system, and should only be done by qualified service personnel.
-
Page 8: Included Pieces
INCLUDED PIECES When unpacking this product, check to make sure parts listed below are included and carefully inspect for any damage that may have occurred during transit. If any part is missing and damaged, do not attempt to assemble or use the product. Handle 2. -
Page 9: Preparation For Operation
5044-032 1600PSI PRESSURE WASHER PREPARATION FOR OPERATION ALWAYS USE THE HANDLE TO TRANSPORT. HOW TO SET UP YOUR UNIT 1. Attach the extension wand to the gun. NOTE: When attaching, align the two projections on the wand with the grooves on the gun. - Page 10 4. Attach the high pressure hose to the pressure water outlet of the machine. Push button to remove hose. If there is a hose with universal connector at hand to use, attach the hose connect adapter (Quick release-thread connect) to the outlet of the machine, then connect the hose to the thread end of hose connect adapter.
- Page 11 5044-032 1600PSI PRESSURE WASHER 6. Attach the garden hose. Connect one end of the garden hose (not supplied) to the adapter and another end to water source. WARNING: The appliance is intended to be used at a temperature above 32˚F/ 0˚C.
-
Page 12: Operation
OPERATION TO WASH WITH WATER 1. Turn on the water supply tap. Connect the washer to the power supply and turn the switch to “ON/I” position. Then press trigger. NOTE: Before pressing trigger, make sure lock-off switch on the triggere is in “unlock” position. - Page 13 5044-032 1600PSI PRESSURE WASHER WARNING! Remember to change the nozzle when the gun is off, to ensure that they do not accidentally eject with force during removal. 0°nozzle-red 15°nozzle-yellow Pull out the nozzle. 25°nozzle-green 40°nozzle-white 4. Cleaning. Begin with the nozzle 1-2’/30-61 cm away from the surface and approach with caution until it reaches the desired position for overly close spray may do harm to surface.
- Page 14 5. Using detergent bottle. a. Fill the container with a detergent or detergent of appropriate formula in proportion to water. Connect the nozzle to the spray gun. b. Squeeze the trigger, detergent will come out through the detergent bottle nozzle. c.
-
Page 15: Maintenance
5044-032 1600PSI PRESSURE WASHER MAINTENANCE WATER FILTER AND NOZZLE CLEANING INSTRUCTIONS A clogged or partially clogged water filter or nozzle can cause significant reduction of water pressure coming out of the nozzle and/or cause the unit to pulsate while spraying. -
Page 16: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE AND SOLUTION Unit will not start. Make sure the power washer is in the “OFF” posi- tion. Plug in the electrical cord to a grounded 120 volt outlet (no electrical extension cord should be used). If the electrical cord will not plug into your outlet, your electrical outlet is not properly ground- ed and should not be used. - Page 17 5044-032 1600PSI PRESSURE WASHER I can’t remove the lance from All lances and detergent tank are attached and the spray gun. What should I removed from the spray gun in the same manner. Insert the quick-release end of the lance togeth- er (about a1/8”/3.175 mm) and turn clockwise.
-
Page 18: Exploded View
EXPLODED VIEW... -
Page 19: Parts
5044-032 1600PSI PRESSURE WASHER PARTS LIST WARNING: When servicing, use only original equipment replacement parts. The use of any other parts may create a safety hazard or cause damage to the Power Washer. Any attempt to repair or replace electrical parts on this Pressure Washer may create a safety hazard unless repairs are performed by a qualified technician.For more informa-... - Page 20 BUAK011027 hose connect adapter (quick release-thread connect) BUAK011028 water inlet screw BUAK011029 high pressure hose BUAK011030 high pressure hose BUAK011031 15° nozzle BUAK011032 25° nozzle BUAK011033 40° nozzle BUAK011034 0° nozzle BUAK011035 detergent tank...
-
Page 21: Warranty
WARRANTY RADLEY PRESSURE WASHER WARRANTY If this Radley tool fails due to a defect in material or workmanship within two years from the date of purchase, it has a 2-year repair warranty with the original bill of sale. This warranty does not include expendable parts including but not limited to blades, brushes, belts, light bulbs and or batteries. - Page 22 © 2021 Home Hardware Stores Limited Made in China 1-866-206-0888 Customer Service/Tech Support This Radley® product carries a two (2) year LIMITED warranty against defects in workmanship and materials. See Owner’s Manual for full details. READ ALL INSTRUCTIONS BEFORE FIRST USE.