Adjusting The Projector Elevation Angle; Rear Projection (From The Back Of The Screen; Connecting A Computer To The Projector - Casio XJ XJ-360 XJ-360 User Manual

Getting Ready

Adjusting the Projector Elevation Angle

You can change the elevation angle of the projector in a range of 0 to 8 degrees. You can
also make fine adjustments to the left and right side elevation angle when necessary.
To change the projector elevation angle
1.
Lift up the front of the projector and press the release
button.
This causes the elevation adjustment foot to drop from the
bottom of the projector.
2.
While holding down the release button, raise and lower
the front of the projector until the elevation adjustment
foot is approximately the length you need.
3.
Release the release button to lock the elevation adjustment foot in its current position.
4.
Rotate the elevation adjustment foot for
fine adjustment of its length.
Longer
To retract the elevation adjustment foot, hold down the release button and slide the
elevation adjustment foot back into the projector. Never try to forcibly change the elevation
adjustment foot position without pressing the release button.

Rear Projection (From the Back of the Screen)

In the case of rear projection, left/right orientation is opposite that of front projection, so you
need to configure the setup menu accordingly. For more detailed operation information, see the
User's Guide (UsersGuide_English.pdf) on the CD-ROM that comes with the projector.

Connecting a Computer to the Projector

You can use the projector to project an image of video output from a computer.
You can also output audio from the computer through the projector's speaker.
Video output to the projector from a computer can be output as-is to an external monitor
connected to the projector.
Always turn off the projector and the computer before connecting them.
Shorter
5.
Use the left and right adjustment feet to
further fine adjust the elevation angle.
Rotate to adjust horizontal alignment.
E-14