Seecode 234207 Manual page 10

Operating instructions
Fill water into the basin. It is recommended to fill warm water below 40 C. Connect
the power supply, the display turns on.
Press the ON/OFF button to start the water bath with massage function. After
switching on, switch on BUBBLE/HEATING for the bubble function and heat the
water up to your desired temperature, then maintain a constant temperature.
Adjust the temperature with the TEMP - and TEMP + buttons for heating up or
lowering. You can choose a temperature according to your comfort between 35° C
and 48° C. For cooling down, we recommend topping up with a little cold water.
After heating up, the set temperature is automatically maintained.
Set the time using the TIMER setting. It can be set freely from 10 to 60 minutes.
Each time you press the key, the time setting changes by 10 minutes. The start
time is automatically set to 30 minutes when the unit is switched on.
Now press the MASSAGE key once to massage the sole of the foot. By default,
the programme sets the massage time to 15 minutes and then switches it off
automatically.
This appliance has touch screen sensor buttons. Do not splash water or other
liquids on the control panel to avoid malfunctions and programme errors.
Programmes
With MODE you can choose between 4 pre-programmed programmes.
These are switched in the following order: MODE 1, MODE 2, MODE 3, MODE 4.
The display shows the programme selected in each case.
The following programmes are available:
MODE 1 - Massage, bubble, heating 42°.
MODE 2 - bubble, heating 40 °
MODE 3 - Massage, bubble, heating 43°.
MODE 4 - Massage, bubble, heating 45°.
10