Fault Code Recovery - Trane P0V0 Series Installer's Manual

Fault Code Recovery

Fault Code Recovery
1. To view the last 6 faults, press the "Menu" key until the "Last 6
Faults" (L6F) menu appears.
2. Enter the menu by pressing the "Option" key.
3. The last 6 faults can be viewed.
Clearing the Last 6 Faults
1. To clear the last 6 faults, press the "Menu" key until the "Last 6
Faults" (L6F) menu appears.
2. Enter the menu by pressing the "Option" key.
3. Hold the "Option" key for at least 5 seconds.
4. Release and a set of 3 dashes with be seen 3 times. This confirms
the faults have been cleared.
Resetting Factory Defaults
1. Display must be in Idle Mode.
2. Push the "Menu" and "Option" buttons at the same time for 15
seconds then release.
3. The 7 segment will flash "FD" 3 times. This confirms the unit has
been reset to the factory defaults.
18-GE20D1-1E-EN
I I n n t t e e g g r r a a t t e e d d M M o o d d u u l l a a r r B B l l o o w w e e r r C C o o n n t t r r o o l l ( ( I I M M B B C C ) ) D D i i s s p p l l a a y y C C o o d d e e s s
EAC, HUM
Dry Contacts
FP
HLI
MVH
MVL
GND
PS2
TH
MVC
HLO
PS1
TR
ILI
12 Pin
Connector
LINE Neutral
Connections Connections
BK W2 W1 R G B/C Y2 Y1 O
Low Voltage Terminal Strip
BK Jumper
5 Amp Fuse
7 Segment LED
MENU and OPTION
Select Buttons
Motor
Communications
Personality
Module
31