Table of Contents
Advertisement
K. WARRANTY VALIDATION FIELD START-UP REPORT (continued)
CUSTOMER:_________________________________
BURNER MODEL: ____________________________ BOILER MODEL: ________________________________
CONTROL CIRCUIT COMPONENT OPERATIONAL TESTING (Check if Okay)
Primary LWCO _______________ High Limit ____________________ Firing Rate Control __________________
Secondary LWCO _____________ Operational Control ____________ Low Fire Start Switch ________________
High Gas Press. Switch _________ High Fire Purge Switch _______________
Low Gas Press. Switch _________ Other _____________________________
FIELD
COMBUSTION SETTINGS
Firing Rate
CO
2
O
2
Smoke or CO (ppm)
NOx (ppm)
o
Stack Temp. Net
F
o
Room Temperature
F
Overfire Draft " WC
Breeching Draft " WC
o
Water Temp.
F/Steam Press.
Air Inlet Shutter (" Open)
Flame Signal Main
Manual Gas Pressure
Combustion Efficiency
Running Motor Amps & Volts
Comments:
Having read the Manufacturer's service manual as to the proper installation, start-up and service of the unit above, I
verify that the burner has been put into operation as specified, and that the above information and checks are com-
plete and correct.
START-UP BY _______________________________________________ Date _________________________
Company ___________________________________________ Phone No. ____________________________
Address ___________________________________________________________________________________
NOTE: Warranty Validation - Field Start-up report must be completed, signed, dated and the top copy sent to Webster
Combustion Technology, Winfield, KS 67156, to validate equipment warranty.
SG Manual
GAS FIRED
Low
Med.
L1
L2
Page 21
High
L3
Warranty Validation - Form #113 (4-02)
W.O. _________________
Advertisement
Table of Contents
