Table of Contents
Advertisement
I. CARE OF THE BURNER DURING EXTENDED SHUTDOWN
Heating equipment is oftentimes located in an environ-
ment conducive to corrosion and general deterioration if
not properly protected and periodically checked, especially
during an extended period of shut down. The following
procedures should be followed if the burner is going to be
placed out of service even for a short period of time.
1. Turn the main manual fuel valve OFF.
ALWAYS KEEP THE MAIN FUEL VALVE(S) OFF IF THE BURNER
IS SHUT DOWN FOR AN EXTENDED PERIOD OF TIME.
The following replacement parts should be stocked to
support uninterrupted burner operation.
Electrode
Blower Wheel
Ignition Transformer
Flame Scanner
Items with greater life expectancy and/or greater dollar
value, such as flame safety controls, main gas valves
and blower motors shopuld be obtained from your local
Webster representative when a need arises.
K. WARRANTY VALIDATION & FIELD START-UP REPORT
As a final step, forward the top copy of the Warranty
Validation and Field Startup Report, Form 113, to:
WEBSTER COMBUSTION TECHNOLOGY, LLC
619 Industrial Road, Winfield, KS 67156.
WEBSTER Series SG Burners are listed by
Underwriters Laboratories, Inc. (U.L.). Also by
the State of Massachusetts Fire Marshall, City
of New York Board of Standards and Appeals,
State of Minnesota, and can be packaged to
meet specific requirements of CSD-1, GE GAP,
IRI, FM, NFPA, MIL or other special insurance or
local code requirements.
SG Manual
CAUTION
J. REPLACEMENT PARTS
2. Turn off the main electrical disconnect to the burner
OFF. Follow tagout / lockout procedures.
3. Place a notification tag or label at the main manual
fuel valve giving reason for shutdown. Follow tagout /
lockout procedures.
4. If the burner is in an area subject to sweating and
condensation, cover the control cabinet and electrical de-
vises with plastic and secure with twine or tape.
5. Should the burner be out of service for more than thirty
(30) days, a complete operational safety check must be
made at the time of restart. The restart must be treated
as a new burner start-up (see burner start-up section in
this manual).
An illustrated parts drawing is included within the Burner
Instructions Manual to aid in parts identification. The name
of the part needed should be established from the draw-
ing, then the part number can be obtained from the burner
material list contained in the Burner Instructions and
service Manual.
Always give Webster Combustion Serial
Number and/or UL Serial Number when
ordering parts.
Page 20
NOTE
Shutdown/Replacement Parts/Warranty
Advertisement
Table of Contents
