Function Of Tipping; Function Of Anti-Frost - HOMCOM 820-276 Instructions Manual

1.Plug in the power cord and turn on the main mechanical switch: the power icon
light is on and the product goes into standby
2.ON/OFF:
It acts as a switch. After shutdown, the machine remembers the state before shutdown
without power off (timer function does not remember)
3、▲/▼：
3.1 In the power-on state, and the timing setting operation is not performed, you can press
"▲" and "▼" to select the set temperature. The setting range is 7-35 ℃; the default tem-
perature is 24 ℃;
3.2 When the machine is in the timing setting state, you can press "▲" and "▼" to select
the timing time, the maximum setting is 24h, zero is no timing;
3.3 In the power-on state, press and hold "▲" and "▼" simultaneously for 5 seconds to
turn on the conversion between the Celsius mode (point + c) and Fahrenheit mode (point +
F).
3.4 In Fahrenheit mode, the default temperature is 75 ° F and the setting range is 45-95 °
F
3.5 The Celsius and Fahrenheit modes have a memory function, and the last mode can
still be remembered after a complete power failure.
4、Appointment/Timer:
Press the reservation (or timer) button to enter the corresponding time setting, the reserva-
tion lamp (or timer lamp) flashes, adjust the time by adding and subtracting keys, automati-
cally confirm after 5 seconds of no operation (maximum setting 24h, 0h is no timer) or
directly press Confirm with the reservation button (or timer button). After confirmation, the
reservation lamp (or timing lamp) will be on continuously. You can set the scheduled pow-
er-on and scheduled power-off at the same time, regardless of the set time, always follow
the principle of first confirmation and first execution;
5、Mode:
5.1 In the power-on state, press this key to switch the heating mode of the machine. The
default Hi file is the first time the power is turned on, and the switching sequence is Hi →
Med → Low → ECO→ Hi →... cycle.
6、Function of tipping:
6.1 When the angle between the machine dumping and the horizontal position is less than
30 ± 5 degrees, the digital tube flashes to prompt "Eo", and all outputs are turned off;
6.2 When the angle between the machine's centering and the horizontal position is greater
than 70 ± 5 degrees, the working state before dumping will be restored.
7、Function of Anti-frost
7.1 In the standby state, the mid-range heating is automatically turned on when the NTC
temperature is lower than 5 ℃ (41 °F), and when the NTC temperature is higher than 7 ℃
(45 °F), the heating is stopped and returned to the standby state.
7.2 When the frost protection function is turned on, the ON/STANDBY key become high-
light and flashes at a frequency of 2 seconds per time, and the display window shows the
room temperature (degrees Celsius or Fahrenheit).
4